Adjustment Points / Calibration Points

This applies only to Special tools and Measuring tools. Here you can enter particular calibration points or measurement points that should be performed by default during adjustment or calibration of tools in this group.

Name

This is where you enter a name for the measuring point. This is what needs to be measured (calibrated) on the tool.

Value

Here you enter an original or initial value, that is used as a reference for the calibration / adjustment point.

Unit

Here you enter the unit used for the initial value.

Allowance +

Here you enter the maximum positive allowance (allowed deviation) for this checkpoint.

Allowance -

Here you enter the maximum negative allowance (allowed deviation) for this checkpoint.

T-unit

Here you enter the unit used for the allowance or deviation.

of